arp-proxy enable | disable
Parameters
enable
Enables the ARP proxy for this topology.
disable
Disables the ARP proxy for this topology.
Example
This example enables the ARP proxy for the test topology:
WLC.siemens.com
:topology:test:l2# arp-proxy enable
multicast
Use the
multicast
command to enter the topology:<named-topology>:l2: multicast context of the CLI
for b@ac, b@ap, physical, and routed topologies.
The following commands are available in the topology:<named-topology>:l2: multicast context.
•
on page 345
•
on page 346
•
•
on page 346
•
on page 347
config
Use the
config
command to configure an existing multicast filter. To create a multicast filter, use the
create
command. See
config
command is available from the
topology:<named-topology>:l2:multicast context of the CLI for b@ac,, b@ap, and routed topologies.
config pos|default (A.B.C.D[/<0-32] | vocera | svp | mdns) on|off
Parameters
pos
|
default
Specifies the priority of filter rule (0–255) or default filter rule.
A.B.C.D[/0-32
] |
vocera
|
svp
|
mdns
Specifies the IP address and mask of a multicast group or that the multicast
group is pre-defined.
•
svp: Spectralink SVP (224.0.1.116)
•
vocera: Vocera Mcst (230.230.0.0/20)
•
mdns mDNS/Bonjour (224.0.0.251)
on
|
off
Specifies whether wireless replication is enabled. The default is off.
Example
This example configures an existing multicast filter:
WLC.siemens.com
:topology:techpubs_test_ac:l2:multicast# config 1
225.1.1.0/32 on
topology Commands
multicast
SCALANCE WLC711 CLI Reference Guide
345
Summary of Contents for scalance WLC711
Page 1: ...SCALANCE WLC711 CLI Reference Guide Release V9 21 14 C79000 G8976 C261 07 Published July 2015 ...
Page 21: ...dns 2 192 1 2 3 dns 3 192 1 3 3 Common Commands show SCALANCE WLC711 CLI Reference Guide 21 ...
Page 376: ...Example topology Commands vlanid SCALANCE WLC711 CLI Reference Guide 376 ...
