R S T P C O N F I G U R A T I O N V I A T E L N E T
Rev H
166 of 244
depends on the hello-time and forward- delay values (between 11 and 30 seconds. The
no
form of this command resets the default value.
NOTE
You cannot assign
MaxAge
a value that is less than 2*(
hello-time
+ 1) or
more than 2*(
forward-delay
– 1).
Command Syntax
IPG.Config.RSTP >
max-age|m
<6-28>
IPG.Config.RSTP >
no max-age|m
Argument Description
6-28
The time, in seconds, during which learned Spanning Tree information is kept before
being discarded. The default value is 20 seconds.
18.2.7 interface
The
interface
command sets the parameters for a specified port. The
no
form of this
command resets to the default value for the port and option specified.
Command Syntax
IPG.Config.RSTP >
interface|i
?
IPG.Config.RSTP >
priority|pr
<0-240>
IPG.Config.RSTP >
edge-port|e
IPG.Config.RSTP >
link-type|1
<auto|a|point-to-point|p|shared|s>
IPG.Config.RSTP >
path-cost|pa <1-200000000>
IPG.Config.RSTP >
force-migration-check|f
IPG.Config.RSTP >
no
interface|i
?
IPG.Config.RSTP >
interface|i
<1-10> priority
IPG.Config.RSTP >
interface|i
<1-10> edge-port
IPG.Config.RSTP >
interface|i
<1-10> link-type
IPG.Config.RSTP >
interface|i
<1-10> path-cost
Argument Description
Command
Value
Description
interface|i
<
1-10
>
Port number of the interface to be configured.
priority|pr
<
0-240
>
Sets priority for the interface at the specified port. Only
values divisible by 16 are accepted (e.g. 0, 16, 32, 48…).
edge-port|e
Marks a port as an edge-port. The no form of this
command disables the edge-port status.
link-type|l
<
auto|a
|point-to-point|p
|shared|s
>
Sets the link type of the port.
Auto
Considers the switch to be connected to a point-to-point
LAN segment if any of the following conditions are true:
a) The switch concerned supports auto-negotiation, and
the auto-negotiation function has determined that the
LAN segment is to be operated in full duplex mode.
b) The switch entity has been configured by management
means for full duplex operation. Otherwise, the MAC is
considered to be connected to a LAN segment that is not
point-to-point (shared media).
Point-to-Point
Considers the switch to be connected to a point-to-point
Summary of Contents for AC - 232 - TX
