!Create a user-defined ACL with the name to be example and specify the order to
be deep precedency.
QTECH(config)#access-list user example match-order auto
5.1.9 {
permit | deny
}
Use this command to add a subitem to ACL with the name ID.
1. Add a subitem to standard ACL with the name ID.
{
permit
|
deny
} { source-addr source-wildcard |
any
} [
fragments
]
[
time-range
time-range-name ]
2. Add a subitem to extended ACL with the name ID.
{
permit
|
deny
} [ protocol ] [
established
] { source-addr source-wildcard |
any
} [ port [ portmask ] ] { dest-addr dest-wildcard |
any
} [ port [ portmask ] ]
[ icmp-type [ icmp-code ] ] { [
precedence
precedence ] [
tos
tos ] |
[
dscp
dscp ] [
fragments
] [
time-range
time-range-name ]
3. Add a subitem to layer 2 ACL with the name ID.
{
permit
|
deny
} [ protocol ] [
cos
vlan-pri ]
ingress
{ { [ source-vlan-id ]
[ source-mac-addr source-mac-wildcard ] [
interface
interface-num ] } |
any
}
egress
{ { [ dest-mac-addr dest-mac-wildcard ] [
interface
interface-num |
cpu
] }
|
any
} [
time-range
time-range-name ]
4. Add a subitem to user-defined ACL with the name ID.
5-55
Summary of Contents for QSW-2900
