E 10210 12 - 2005
Protocols:
MODULAR X6 CCTALK VALIDATOR 52
Using this command the Validator informs the Machine what the inhibit bit corresponding to
the coin code is:
Send:
[Dir] [1] [1] [212] [Data 1] [Chk]
Reply:
[1] [2] [Dir] [0] [Data 2] [Data 3] [Chk] -> ACK with two data
Where
Dir = address of the corresponding validator
Data 1: coin code
Data 2: LSB of the inhibit word
Data 3: MSB of the inhibit word
The value returned (2 bytes: word) has the bit corresponding to the coin code requested
activated to “1”. The values correspond to the following commands:
-
Coin code: code returned in the command READ BUFFERED CREDIT OR ERROR CODES
[229].
-
Inhibit word: value of the coin inhibits – coins to admit or reject, used in the commands
REQUEST INHIBIT STATUS [230], and MODIFY INHIBIT STATUS [231].
Command protected by a PIN.
Notes:
a)
A NACK is returned if:
-
The Exit module does not have its software correctly loaded.
-
The coin code is greater than 16 (erroneous argument)
b) The Validator does not answer if it is programmed in “L66 compatibility” mode.
5.34
MODIFY SORTER PATHS [210]
This command is used to configure in the Validator the sorter path that each coin is assigned.
Two formats of the command are admitted:
Format (a):
Send:
[Dir] [2] [1] [210] [Data 1] [Data 2] [Chk]
Reply:
[1] [0] [Dir] [0] [Chk] -> ACK without data
