E 10210 12 - 2005
Protocols:
MODULAR X6 CCTALK VALIDATOR 57
-
All introduced coins will be accepted by the Validator.
The state of the auto programming of coins can be consulted using the command REQUEST
TEACH STATUS [201].
Command protected by a PIN.
Notes:
a)
A NACK is returned if:
-
The Exit module does not have its software correctly loaded.
-
The Validator is not programmed in Factory to accept the auto programming of the
coin requested.
-
There has been an error in programming the data in the Flash memory of the Sensor
module or of the Exit module.
b)
BUSY is returned (6) if the Validator is busy measuring or accepting a coin at the
moment of receiving the command.
c)
This command is not available if the Validator is working in “Secure Mode”.
5.37
REQUEST TEACH STATUS [201]
Command not available in “Secure Mode”.
The Machine requests the Validator for information about the auto programming process.
The process of auto programming can be finalised by the Validator or the Machine can also
abort it at any given moment.
Send:
[Dir] [1] [1] [201] [Data 1] [Chk]
Reply:
[1] [2] [Dir] [0] [Data 2] [Data 3] [Chk] -> ACK with 2 data
Where
Dir = address of the corresponding validator
Data 1 = 0: Indicates if the machine is requesting information.
= 1: Indicates that the machine is aborting the process of auto
programming.
Data 2 = Number of coins introduced.
