100
unset <keyword>
end
get log trafficfilter
show log trafficfilter
The config log trafficfilter command has 1 subcommand.
config rule
log trafficfilter command keywords and variables
Keywords & Variables Description
Default
display {name | port}
Enter name to enable the display of the service
name in the traffic log messages. Enter port to
display the port number used by traffic in traffic
log messages.
port
resolve {disable |
enable}
Enter enable to enable resolving IP addresses
to host names in traffic log messages.
disable
Example
This example shows how to display the service name and enable resolving IP addresses to host
names in log messages.
config log trafficfilter
set display name
set resolve enable
end
This example shows how to display the settings for the log trafficfilter command.
get log trafficfilter setting
This example shows how to display the configuration for the log trafficfilter command.
show log trafficfilter setting
If the show command returns you to the prompt, the settings are at default.
config rule
Access the
rule
subcommand using the
log trafficfilter
command.
Use the following command to configure traffic filter rules based on source IP address, destination IP
address, and service (protocol).
Summary of Contents for freeGuard 100
