142
show router prefix-list prf_list1
Command History
Related Commands
•
config router access-list
•
config router rip
8.10 rip
Use this command to configure routing information protocol (RIP) on the FreeGuard 100.
The freeGuard 100 implementation of RIP supports both RIP version 1 as defined by RFC 1058, and
RIP version 2 as defined by RFC 2453. RIP version 2 enables RIP messages to carry more
information, and to support simple authentication and subnet masks.
RIP is a distance-vector routing protocol intended for small, relatively homogeneous, networks. RIP
uses hop count as its routing metric. Each network is usually counted as one hop. The network
diameter is limited to 15 hops.
Command syntax pattern
config router rip
set <keyword> <variable>
end
config router rip
unset <keyword>
end
get router rip
show router rip
The configrouter rip command has 7 subcommands.
config distance
config distribute-list
config interface
config neighbor
config network
config offset-list
config redistribute
rip command keywords and variables
Summary of Contents for freeGuard 100
