194
set mac 00:09:0F:0A:01:BC
end
This example shows how to display the settings for the system dhcp ipmacbinding command.
get system dhcp ipmacbinding
This example shows how to display the settings for the ipmac_pair IP/MAC binding pair.
get system dhcp ipmacbinding ipmac_pair
This example shows how to display the configuration for the system dhcp ipmacbinding command.
show system dhcp ipmacbinding
This example shows how to display the configuration for the ipmac_pair IP/MAC binding pair.
show system dhcp ipmacbinding ipmac_pair
Command History
Related Commands
•
dhcp exclude_range
•
dhcp server
•
interface
10.12 dhcp server
Use this command to add one or more DHCP servers for any freeGuard 100 interface. As a DHCP
server, the interface dynamically assigns IP addresses to hosts on a network connected to the
interface.
You can add more than one DHCP server to a single interface to be able to provide DHCP services to
multiple networks. For more information on configuring your network and freeGuard 100 to use
multiple DHCP servers on one interface, see the System DHCP chapter in the Administration Guide
for your freeGuard 100.
Note:
For this configuration to take effect you must set the interface to DHCP server mode using the
dhcpserver-mode keyword in the config system interface command.
You can configure up to 32 DHCP servers.
Command syntax pattern
config system dhcp server
edit <name_str>
Summary of Contents for freeGuard 100
