200
•
operation
mode
•
host name
•
current virtual domain
•
current HA status
Command syntax pattern
get system status
10.17 global
Use this command to configure global settings that affect various freeGuard 100 systems and
configurations.
Command syntax pattern
config system global
set <keyword> <variable>
end
config system global
unset <keyword>
end
get system global
show system global
system global command keywords and variables
Keywords &
Variables
Description
Default
admintimeout
<minutes_integer>
Set the administrator idle timeout to control the amount of
inactive time before the administrator must log in again.
Themaximum admintimeout is 480 minutes (8 hours). To
improve security keep the idletimeout at the default value.
5
allow-interface-
subnetoverlap {disable
| enable}
Enable or disable limited support for interface and VLAN
subinterface IP address overlap. Use this command to enable
limited support for overlapping IP addressesin an existing
network configuration. Caution: for advanced users only. Use
thisonly for existing network configurations that cannot be
changed to eliminate IP address overlapping.
disable
asymroute {disable
|enable}
Enable or disable support for asymmetric routing. Using
asymmetric routing, packetsthat are part of the same session
traveldifferent routes and pass through different gateways.
disable
authtimeout
<minutes_integer>
Set the firewall user authentication time out to control the
amount of inactive time before the user must authenticate
5
Summary of Contents for freeGuard 100
