132
designated router (BDR). An interface with
router priority set to 0 can not be elected DR
or BDR. The interface with the highest router
priority wins the election. If there is a tie for
router priority, router ID is used. Point-to-point
networks do not elect a DR or BDR; therefore,
this setting has no effect ona point-to-point
network. The valid range for
priority_integer
is 0 to 255.
retransmit-interval <seconds_integer> The time, in seconds, to wait before sending a
LSA retransmission. The value for the
retransmit interval must be greater than the
expected round-trip delay for a packet. The
valid range for
seconds_integer
is 1 to
65535.
5
status {disable | enable}
Enable or disable OSPF on this interface.
enable
transmit-delay <seconds_integer>
The estimated time, in seconds, required
tosend a link state update packet on this
interface. OSPF increments the age of the
LSAs in theupdate packet to account for
transmissionand propagation delays on the
interface. Increase the value for transmit-
delayon low speed links. The valid range for
seconds_integer
is 1 to 65535.
1
Example
This example shows how to assign an OSPF interface configuration named test to the interface
named internal and how to configure text authentication for this interface.
config router ospf
config ospf-interface
edit test
set interface internal
set ip 192.168.20.3
set authentication text
set authentication-key a2b3c4d5e
end
end
This example shows how to display the settings for the OSPF interface configuration named test.
config router ospf
Summary of Contents for freeGuard 100
