freeGuard 100 CLI User Manual
157
Related Commands
•
config router access-list
•
config router prefix-list
•
config router rip
8.12 static
Use this command to add, edit, or delete static routes for IPv4 traffic.
Add static routes to control the destination of traffic exiting the freeGuard 100. You configure routes by
adding destination IP addresses and netmasks and adding gateways for these destination addresses.
The gateways are the next hop routers to which to route traffic that matches the destination addresses
in the route.
You can also configure the administrative distance for a route to indicate the order of preferability
when more than one route is available to the same network. The lower the administrative distance the
greater the preferability of the route.
The freeGuard 100 assigns routes using a best match algorithm. To select a route for a packet, the
freeGuard 100 searches through the routing table for a route that best matches the destination
address of the packet. If a match is not found, the freeGuard 100 routes the packet using the default
route.
Command syntax pattern
config router static
edit <sequence_integer>
set <keyword> <variable>
end
config router static
edit <sequence_integer>
unset <keyword>
end
config router static
delete <sequence_integer>
end
get router static [<sequence_integer>]
show router static [<sequence_integer>]
static command keywords and variables Example
Keywords & Variables
Description
Default
device <interfacename_str>
The name of the freeGuard 100 interface
through whichto route traffic.
null
distance <distance_integer>
The administrative distance for the route. Using
10
Summary of Contents for freeGuard 100
