freeGuard 100 CLI User Manual
73
numbers at www.iana.org.
protocol {ICMP | IP |
TCP | UDP}
Enter the protocol used by the service.
No default.
protocol-number
<protocol_integer>
Enter the Internet protocol number. You can findInternet
protocol numbers at www.iana.org.
No default.
Example
This example shows how to add a custom service called Custom_1. The service can use any source
port. The service destination port range is TCP 4501 to 4503.
config firewall service custom
edit Custom_1
set protocol TCP
set srcport 1-65535
set dstport 4501-4503
end
This example shows how to display the settings for the firewall service custom command.
get firewall service custom
This example shows how to display the settings for the Custom_1 service.
get firewall service custom Custom_1
This example shows how to display the configuration for the firewall service custom command.
show firewall service custom
This example shows how to display the configuration for the Custom_1 service.
show firewall service custom Custom_1
Command History
Related Commands
•
policy
5.13 service group
Use this command to add, edit, or delete firewall service groups.
To make it easier to add policies, you can create groups of services and then add one policy to provide
or block access for all the services in the group. A service group can contain predefined services and
custom services in any combination. You cannot add service groups to another service group.
Note:
To edit a service group, you must enter all of the members of the service group, both those you
are changing and those that are staying the same.
Command syntax pattern
Summary of Contents for freeGuard 100
