52
addresses randomly selected from the IP pool rather than being limited to the IP address of the
destination interface. IP pools are only available in NAT/Route mode. You can add multiple IP pools to
any interface and configure the firewall policy to select the IP pool to use for that firewall policy.
Command syntax pattern
config firewall ippool
edit <id_integer>
set <keyword> <variable>
end
config firewall ippool
edit <id_integer>
unset <keyword>
end
config firewall ippool
delete <id_integer>
end
get firewall ippool [<id_integer>]
show firewall ippool [<id_integer>]
firewall ippool command keywords and variables
Keywords and
variables
Description
Default
endip <address_ipv4>
The end IP of the address range. The end IP must be
higher than the start IP. The end IP must be onthe same
subnet as the IP address of the interface for which you
are adding the IP pool.
0.0.0.0
interface <name_str>
Add an IP pool with the specified start and end IP
addresses to the named interface. The interface can
also be a VLAN subinterface.
No default.
startip <address_ipv4> The start IP of the address range. The start IP must be
lower than the end IP. The start IP must be on the same
subnet as the IP address of the interface for which you
are adding the IP pool.
0.0.0.0
Example
Use the following command to add an IP pool with these settings to the firewall configuration.
•
ID number: 1
•
interface name: internal
•
start of IP address range: 192.168.1.100
•
end of IP address range: 192.168.1.200
Summary of Contents for freeGuard 100
