158
administrative distance you can specify the
relative priorities of different routes to the same
destination. A lower administrative distance
indicates a more preferred route. Distance can
be an integer from 1-255. See also config
system interface “distance <distance_integer>”
on page 261.
dst
<destinationaddress_ipv4mask>
The destination IP address and netmask for this
route. Enter 0.0.0.0 0.0.0.0 for the destination IP
address and netmask to add a default route.
0.0.0.0 0.0.0.0
gateway
<gatewayaddress_ipv4>
The IP address of the first next hop router to
which this route directs traffic.
0.0.0.0
This example shows how to add a static route that has the sequence number 2.
config router static
edit 2
set dev internal
set dst 192.168.22.0 255.255.255.0
set gateway 192.168.22.44
end
This example shows how to display the list of static route numbers.
get router static
This example shows how to display the settings for static route 2.
get router static 2
This example shows how to display the static route configuration.
show router static
This example shows how to display the configuration for static route 2.
show router static 2
Command History
Related Commands
•
config system interface
•
get router info routing_table
Summary of Contents for freeGuard 100
