130
end
config ospf-interface
edit <interface-name_str>
show
end
Note:
The interface and ip keywords are required. All other keywords are optional.
ospf-interface command keywords and variables
Keywords & Variables
Description
Default
authentication {md5 | none | text}
Use the authentication keyword to define the
authentication used for OSPF packets sent
and received by this interface. If you select
none, no authentication is used. If you select
text, the authentication key is sent as plain
text. If you select md5, the authentication key
is used to generate an MD5 hash. Both text
mode and MD5 mode only guarantee the
authenticity of the update packet, not the
confidentiality of the routing information in the
packet. In text mode the key is sent in clear
text over the network. Text mode is usually
used only to prevent network problems that
can occur if an unwanted or misconfigured
router is mistakenly added to the network. If
you configure authentication for the interface,
authentication for areas is not used. All routers
on the network must use the same
authentication type.
none
authentication-key <password_str>
Enter the password to use for text
authentication. The authentication-key must
be the same on all neighboring routers. The
maximum length for the authentication-key is
15 characters.
No default.
cost <cost_integer>
Specify the cost (metric) of the link. The cost is
used for shortest path first calculations.
10
database-filter-out {disable | enable}
Enable or disable flooding LSAs out of this
interface.
disable
dead-interval <seconds_integer>
The time, in seconds, to wait for a hello packet
before declaring a router down. The value of
the dead-interval should be four times the
value of the hello-interval. All routers on the
network must use the same value for dead-
interval. The valid range for
seconds_integeris
1 to 65535.
40
Summary of Contents for freeGuard 100
