Cryo-con Model 24C
Remote Programming Guide
Network Commands
The following commands are used to configure the Model 24C's Ethernet interface.
NETWork:IPADdress
"
IPA
"
Sets or queries the controller's IP address. The address is expressed as an
ASCII string, so the input parameter must be enclosed in quotes. For
example, the default IP address parameter is 192.168.1.5".
NETWork:PORT <port number>
Sets or queries the controller's TCP port number. Default is 5000.
NETWork:NAMe "Name"
Sets or queries the controller's network name. This name is expressed as an
ASCII string, so the input parameter must be enclosed in quotes. Maximum
of 15 characters.
NETWork:DHCP
{ON | OFF}
Sets or queries the controller's DHCP status.
NETWork:MACADdress?
Queries the controller's MAC address. The address is returned as an ASCII
string. Cryo-con MAC addresses range from 00:50:C2:6F:40:00 to
00:50:C2:6F:4f:ff. They cannot be changed by the user.
Mail Commands
The Model 24C can send e-mail over the Ethernet port when an alarm condition is
asserted on an enabled input channel. The following remote commands are used to
configure e-mail. However, it is much easier to configure e-mail using the controller's
embedded web server.
{A | B | C | D}
:ADDR
"
IPA
"
Set or query the e-mail server IP address. Parameter format is an ASCII
string and must be enclosed in quotation marks. For example: 192.168.0.1".
{A | B | C | D}
:FROM
"
from e-mail address
"
Set or query the 'from' e-mail address. Parameter is an ASCII String. For
example: Model24C@mynetwork.com".
{A | B | C | D}
:DEST
"
to e-mail address
"
Set or query the 'from' e-mail address. Parameter is an ASCII String. For
example: Model24@mynetwork.com".
{A | B | C | D}
:PORT <port number>
Set or query the e-mail port. Parameter is integer and default is 25.
{A | B | C | D}
:STATE
{ON | OFF}
Set or query the input channel e-mail send enables. If a channel is enabled,
e-mail will be sent when an alarm condition is asserted on the selected input
channel.
136
