69-3
To do…
Use the command…
Remarks
Download/Upload files from
TFTP server
tftp ipv6 remote-system
[
-i
interface-type
interface-number
] {
get
|
put
}
Required
source-filename
[
destination-filename
]
Available in user view
When you use the
tftp ipv6
command to connect to the TFTP server, you must specify the “–
i
” keyword
if the destination address is a link-local address.
IPv6
s used to
s. The device can be used either as a Telnet client or a Telnet
nt application of IPv6 to set up an IPv6
lnet server. If Device A again connects to
ce B is the Telnet server.
Telnet
Telnet protocol belongs to application layer protocols of the TCP/IP protocol suite, and i
provide remote login and virtual terminal
server.
As the following figure shows, the Host is running Telnet clie
Telnet connection with Device A, which serves as the Te
Device B through Telnet, the Device A is the Telnet client and Devi
Figure 69-2
Provide Telnet services
Device A
Device B
Host
Telnet Client
Telnet Server
Telnet Client
Telnet Server
Configuration prerequisites
E
r
ethod.
in
O
manual.
ollow these steps to set up IPv6 Telnet connections:
nable Telnet on the Telnet serve
peration
in this
and configure the authentication m
For details, refer to
Log
F
To do…
Use the command…
Remarks
Perform the
telnet
command
telnet ipv6 remote-system
[
-i
Required
on the Telnet client to log in to
other devices
interface-type interface-number
]
[
port-number
]
Available in user view
When you u
net ipv6
comma
elnet server, you
cify the “–
i
”
keyword if the destination address is a link-local address.
se the
tel
nd to connect to the T
must spe
