To do…
Use the command…
Remarks
Enable information
output for a specified
switch in a fabric
ll
}
ging
|
trapping
]*
output
n
and trap
information output are all disabled for
other switches in the fabric.
info-center switch-on
{
unit
unit-id | master | a
[
debugging
|
log
Optional
By default, debugging information
is enabled, and log and trap informatio
output are disabled for the master switch
in a fabric. Debugging, log
Enable system
information output to a
log host
er
|
channel
-
name
}
| facility
After you configure the switch to output
n to the log host, the switch
info-center loghost
host
-
ip
-
addr
[
channel
{
channel
-
numb
local
-
number
]*
Required
By default, the switch does not output
information to the log host.
informatio
uses information channel 2 by default.
Configure the source
interface through which
ation is sent to
st
info-center loghost source
interface-type
interface-number
By default, no source interface is
configured, and the system
automatically selects an interface as the
source interface.
Optional
log inform
the log ho
Config
rul
inf
ure the output
es of system
ormation
info
-
center source
{
modu
-
name
|
default
}
channel
{
channel
-
number |
channel
-
name
} [ {
log
|
trap
|
debug
} {
level
severity
|
state
state
} ]*
Optional
Refer to
Table 59-4
for the default output
rules of system information.
Set the forma
sta
o the
g
loghost
{
date
|
By default, the time stamp format of the
t of the time
mp to be sent t
info-center timestamp
Optional
lo host
no-year-date
|
none
}
information output to the log host is
date
.
z
info-center switch-on
command to enable the
ap information of each switch
in the fabric synchronous. Each switch send
n to other switche
and
receive
y other switch
update the information on itself. In
itch en
hronization of log, debug
g and trap information in the
z
ure to set the correc
ing the
info-center
loopback IP
address will cause an error message prompting that this address
.
After the switches form a fabric, you can use the
information output for the switches to make the log, debugging and tr
s its own informatio
es at the same time to
s in the fabric
s information sent b
this way, the sw
sures the sync
gin
whole fabric.
Be s
t IP address when us
loghost
command. A
is invalid
Setting to Output System Information to the Trap Buffer
Follo
et to
buf
w these steps to s
output system information to the trap
fer:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enable the information
center
info-center enable
Optional
Enabled by default.
59-12
