SECTION 5
Communications and Device Support
5-10 PEN*KEY
R
6200/6300 Hand-Held Computer Programmer’s Reference Guide
PROTOCOL=
This parameter indicates the protocol to be used:
"
3 = TTY
"
4 = NPCP (LAN)
"
14 = NRInet
Example:
PROTOCOL=3
ROUTER=
Supported in PSROM0C V3.xx only.
This is the router IP address.
SPEED=
Indicates the TCOM speed for twoĆway TTY. This parameter should be omitted
if NPCP protocol is specified.
Valid values:
1200, 2400, 9600, 19200, 38400, 57600, or 115200.
Example:
SPEED=2400
STOPBITS=
Valid only if twoĆway TTY protocol was specified.
Valid values:
1 = One stop bit
2 = Two stop bits
3 = 1 1/2 stop bits
Example:
STOPBITS=1
TRIES=
Specifies the number of times to attempt a successful communication session. If
TRIES is exhausted before a session is successful, PSROM0C.EXE returns the
error of the last session. A parameter value of 0 indicates that the retry is to
continue until a session is successful or until the user aborts.
Example:
Control File for NPCP:
PROTOCOL=4
Example:
Control File for NRInet: PROTOCOL=14
IPHOST=nnn.nnn.nnn.nnn
Example:
Control File for TTY:
PROTOCOL=3
COM=1
SPEED=9600
PARITY=0
DATABITS=8
STOPBITS=1
5. Communications
and Device Support
