Lantronix
SISPM1040-582-LRT CLI Reference
33757 Rev. J
Page
209
of
272
26 Interface Config Mode Commands
These Interface Config mode commands let you configure a specified interface:
*
All switches or All ports
GigabitEthernet 1 Gigabit Ethernet Port
vlan VLAN interface configurations
Command
Function
access-list
Access list
aggregation Create an aggregation
debug Debugging functions
description
Configures port description
do
To run exec commands in config mode
dot1x IEEE Standard for port-based Network Access Control
duplex
Interface duplex
end Go back to EXEC mode
evc Ethernet Virtual Connections
event Configure port event settings
excessive-restart Restart backoff algorithm after 16 collisions
exit Exit from current mode
flowcontrol Traffic flow control.
frame-length-check Drop frames with mismatch between EtherType/Length field and actually payload size.
green-ethernet Green ethernet (Power reduction)
gvrp Enable GVRP on interface or interfaces
help Description of the interactive help system
ip Internet Protocol
ipv6
IPv6 configuration commands
lacp Enable LACP on this interface
link-oam Enable or Disable(when the no keyword is entered) Link OAM on the interface
lldp
LLDP configurations.
loop-protect Loop protection configuration on port
mac MAC keyword
mtu
Maximum transmission unit
mvr
Multicast VLAN Registration configuration
no
Negate a command or set its defaults
poe
Power Over Ethernet.
port-security
Enable/disable port security per interface.
ptp
Precision time Protocol (1588)
pvlan
Private VLAN
qos
Quality of Service
rmon
Configure Remote Monitoring on an interface
sflow
Statistics flow.
shutdown
Shutdown of the interface.
spanning-tree
Spanning Tree protocol
speed
Configures interface speed.
switchport
Switching mode characteristics
udld
UDLD configurations.
