Lantronix
SISPM1040-582-LRT CLI Reference
33757 Rev. J
Page
212
of
272
debug phy loopback [ near | far ]
debug phy mmd read <devad> <mmd_reg_addr>
debug phy mmd write <devad> <mmd_reg_addr> <value>
debug phy ob-post0 <value>
debug phy patch-settings-get
debug phy read <addr_list> [ <page> ] [ addr-sort ]
debug phy reset
debug phy statistic
debug phy write <addr_list> <value> [ <page> ]
debug show capabilities
debug show change [ up | down ]
debug trace port [ enable | disable ]
Parameters
:
clear clear keyword.
eee Powering down of PHYs when there is no traffic.
kr-conf Show or set the 10GBASE-KR parameters.
link-oam Link OAM configuration
mode
debug mode
no Negate a command or set its defaults
phy PHY register access
show Show keyword
trace Trace setting
Example
:
SISPM1040-582-LRT(config-if)#
debug eee wakeup-time
SISPM1040-582-LRT(config-if)#
Command
:
description
Description
:
Configure port description for an interface.
Syntax
:
description
<description>
Parameters
: <line128> Up to 128 characters describing this interface
Example
:
SISPM1040-582-LRT(config-if)#
description 582-lrt
SISPM1040-582-LRT(config-if)#
Command
:
do
Description
:
Run Exec mode commands in Interface Config mode.
Syntax
:
do
<command>
Parameters
: <line> Exec Command
Example
:
SISPM1040-582-LRT(config-if)#
do show ip int brief
Vlan Address Method Status
---- -------------------- -------- ------
1 192.168.1.77/24 Manual UP
SISPM1040-582-LRT(config-if)# do show vlan