Lantronix
SISPM1040-582-LRT CLI Reference
33757 Rev. J
Page
30
of
272
<0-255>
Policy ID
policy-bitmask
The bitmask for policy ID
<0x0-0xFF>
The value of policy bitmask
<1-4095>
The value of VID field
<0-7>
The value of tag priority
dip Destination IP address field
ip-flag IP flag
ip-protocol
IPv4 protocol field
logging Logging frame information. Note: The logging feature only works when the packet length
is less than 1518 (without VLAN tags) and the System Log memory size and logging rate is
limited.
mirror Mirror frame to destination mirror port
next insert the current ACE before the next ACE ID
policy Policy
shutdown Shutdown incoming port. The shutdown feature only works when the packet length is
less than 1518 (without VLAN tags).
sip Source IP address field
tag Tag
Example
:
SISPM1040-582-LRT(config)#
access-list ace 10 action deny
SISPM1040-582-LRT(config)#
access-list ace 1 dmac-type broadcast frame-type ipv4-tcp
SISPM1040-582-LRT(config)#
access-list ace 2 action deny dmac-type broadcast rate-limiter 1 redirect
interface GigabitEthernet 1/4 tag untagged
% The specific DMAC type(unicast, multicast or broadcast) is not supported when ACE any frame type.
SISPM1040-582-LRT(config)#
Command
:
rate-limiter
Description
:
Configure Rate limiter.
Syntax
:
access-list rate-limiter
[ <rate_limiter_list> ] { pps <pps_rate> | 10pps <pps10_rate> | 100pps
<pps100_rate> | 25kbps <kpbs25_rate> | 100kbps <kpbs100_rate> }
Parameters
: 100kbps 100k bits per second
<1~16> Rate limiter ID
pps Packets per second
<0-10000> Rate value
<0-3276700> Rate value
Example
:
SISPM1040-582-LRT(config)#
access-list rate-limiter 100kbps 111
SISPM1040-582-LRT(config)#
access-list rate-limiter 100kbps 500
SISPM1040-582-LRT(config)#
access-list rate-limiter 1 pps 90000
SISPM1040-582-LRT(config)#