Lantronix
SISPM1040-582-LRT CLI Reference
33757 Rev. J
Page
221
of
272
Command
:
lacp
Description
:
Enable LACP on this interface.
Note
that Static aggregation must be disabled.
Syntax
:
lacp
lacp
key { <v_1_to_65535> | auto }
lacp
port-priority <v_1_to_65535>
lacp
role { active | passive }
lacp
timeout { fast | slow }
Parameters
: key Key of the LACP aggregation
port-priority LACP priority of the port
role Active / Passive (speak if spoken to) role
timeout The period between BPDU transmissions
<1-65535> Key value
auto Choose a key based on port speed
fast
Transmit BPDU each second (fast timeout)
slow
Transmit BPDU each 30th second (slow timeout)
active
Transmit LACP BPDUs continuously
passive
Wait for neighbor LACP BPDUs before transmitting
<1-65535> Priority value, lower means higher priority
<cr>
Example
:
SISPM1040-582-LRT(config-if)#
lacp key 1
SISPM1040-582-LRT(config-if)#
lacp role passive
SISPM1040-582-LRT(config-if)#
lacp role active
SISPM1040-582-LRT(config-if)#
lacp port-priority 1
SISPM1040-582-LRT(config-if)#
lacp key auto
SISPM1040-582-LRT(config-if)#
lacp timeout fast
SISPM1040-582-LRT(config-if)#
lacp timeout slow
SISPM1040-582-LRT(config-if)#
Messages
:
Error:Static aggregation is enabled
Could not set LACP parameter