Lantronix
SISPM1040-582-LRT CLI Reference
33757 Rev. J
Page
33
of
272
Command
:
debug
Description
:
Debugging functions in Config mode. Note that there are also Exec mode and Interface Config
mode debug commands.
Warning
: The use of 'debug' commands may negatively impact system behavior. Do not enable unless instructed
to. Some debug commands when enabled they stay on, consuming CPU and memory and ultimately slowing the
system down.
Note
: 'debug' command syntax, semantics and behavior are subject to change without notice.
Note
: Debug commands are only for use by, or at the direction of Lantronix Technical Support.
Command
:
default
Description
:
Set a command to its defaults.
Syntax
:
default
access-list rate-limiter [ <rate_limiter_list> ]
Parameters
: access-list Access list
rate-limiter Rate limiter
<1~16> Rate limiter ID
<cr>
Example
:
SISPM1040-582-LRT(config)#
default access-list rate-limiter 1
SISPM1040-582-LRT(config)#
default access-list rate-limiter
SISPM1040-582-LRT(config)#
Command
:
dms
Description
:
Set DMS service mode (Device Management System)
Syntax
:
dms
service-mode { disabled | enabled [ priority { high | mid | low | non } ] }
Parameters
: service-mode DMS mode
disabled DMS mode is disabled
enabled DMS mode is enabled
priority DMS priority. Choose a DMS priority level for the switch.
high
DMS priority is high; this switch will be the DMS Controller (Master) switch.
low
DMS priority is low priority (default)
mid
DMS priority is mid-level priority
non
DMS priority is non; the switch will never become the Controller (Master) switch.
Example
:
SISPM1040-582-LRT(config)#
dms service-mode enabled
SISPM1040-582-LRT(config)#
dms service-mode enabled priority mid
SISPM1040-582-LRT(config)#
dms service-mode enabled priority high
SISPM1040-582-LRT(config)#