Lantronix
SISPM1040-582-LRT CLI Reference
33757 Rev. J
Page
80
of
272
Command
:
ptp
Description
:
Configure Precision Time Protocol (1588).
Syntax
:
ptp
<clockinst> clk sync <threshold> ap <ap>
ptp
<clockinst> domain <domain>
ptp
<clockinst> filter [ delay <delay> ] [ filter-type { basic | ms-pdv } ] [ period <period> ] [ dist <dist> ]
ptp
<clockinst> ho [ filter <ho_filter> ] [ adj-threshold <adj_threshold> ]
ptp
<clockinst> log <debug_mode>
ptp
<clockinst> mode { boundary | e2etransparent | p2ptransparent | master | slave | bcfrontend } [ onestep |
twostep ] [ ethernet | ethernet-mixed | ip4multi | ip4mixed | ip4unicast | oam | onepps ] [ oneway | twoway ] [
id <v_clock_id> ][ vid <vid> [ <prio> ] [ tag ] ] [ mep <mep_id> ] [ profile { ieee1588 | g8265.1 | g8275.1 } ] [ clock-
domain 0 ] [ dscp <dscp_id> ]
ptp
<clockinst> priority1 <priority1>
ptp
<clockinst> priority2 <priority2>
ptp
<clockinst> servo ad <ad>
ptp
<clockinst> servo ai <ai>
ptp
<clockinst> servo ap <ap>
ptp
<clockinst> servo displaystates
ptp
<clockinst> servo phase-mode
ptp
<clockinst> slave-cfg [ stable-offset <stable_offset> ] [ offset-ok <offset_ok> ] [ offset-fail <offset_fail> ]
ptp
<clockinst> time-property [ utc-offset <utc_offset> ] [ valid ] [ leap-59 |leap-61 ] [ time-traceable ] [ freq-
traceable ] [ ptptimescale ] [ time-source <time_source> ]
ptp
<clockinst> uni <idx> [ duration <duration> ] <ip>
ptp
ext [ output | input | out-in ] [ ext <clockfreq> ] [ vcxo | ltc-freq | synce-dpll | osc | ltc-phase ]
ptp
ref-clock { mhz125 | mhz156p25 | mhz250 }
ptp
system-time { get | set }
ptp
tc-internal [ mode <mode> ]
Parameters
:
<0-3>
Clock instance [0-3]
ext
Update 1PPS and External clock output config and vcxo frequency rate adjustment option
system-time
Enable synchronization between PTP time and system time
tc-internal
Define the internal mode used in TC's
clk
Set PTP slave clock options
domain Clock domain for PTP
filter
Set filter parameters
ho Set PTP Servo holdover parameters
log
Set the PTP debug mode
mode Enable a PTP instance
priority1
Clock priority 1 for PTP BMC algorithm (0 is highest priority)
priority2
Clock priority 2 for PTP BMC algorithm (0 is highest priority)
servo
Set Servo parameters
slave-cfg
Set PTP clock Slave Configuration
time-property
Set time properties
uni Set a Unicast Slave configuration entry
<1-1000>
[1..1000] Threshold in ns for offsetFromMaster defines when the offset
increment/decrement mode is entered
ap
Set the adjustment factor