C
ONFIGURATION
C
OMMAND
S
ET
- F
IRMWARE
R
EVISION
2.4.0_
BETA
-
V
ERSION
1.0.0
3.2.10.1 DEVICE parameters
3.2.10.2 DEVICE.NAME
Parameter syntax
This parameter sets or changes the device name.
<name>
It defines a (new) device name. When the device sends out a message, it
identifies itself with this name.
How to set/get Device configuration:
Set configuration
$PFAL,Cnf.Set,DEVICE.NAME=alfa_car
Get configuration
$PFAL,Cnf.Get,DEVICE.NAME
Notes
•
If the device name has already been set, each other
sent to the
device overwrites the existing entry.
3.2.10.3 DEVICE.CMD.PFAL.EN
Parameter syntax
This parameter enables or disables communication on specific channel. It protects
the device from reconfiguration via a specific channel (for example, via SMS). This
configuration prevents only the execution of the incoming commands from the
corresponding disabled channel and not when a command is automatically
executed by the system MAMBOII as an alarm (
AL
).
<
hex_value
>
It specifies whether to enable or disable a specific communication channel.
Specify a hexadecimal number or the sum for the channels to be enabled
without using the “
0x
”.
Value
Meaning
0x0
1
Enables a bi-directional communication on the
serial
channel
.
Messages can be sent and received. If this value
is omitted, messages can only be received but not sent to
the device (unidirectional communication).
0x0
2
Enables a bi-directional communication on a
CSD
call.
Data can be sent and received. If this value is omitted,
data can only be received but not sent to the device
(unidirectional communication).
0x0
4
Enables a bi-directional communication on a
TCP
line.
Messages can be sent and received. If this value is
omitted, messages can only be received but not sent to
the device (unidirectional communication).
0x0
8
Enables a bi-directional transmission of
SMS
messages.
Messages can be sent and received. If this value is
omitted, messages can only be received but not sent to
the device (unidirectional communication).
How to set/get Device configuration:
Set configuration
$PFAL,Cnf.Set,DEVICE.CMD.PFAL.EN=
A
Get configuration
$PFAL,Cnf.Get,DEVICE.CMD.PFAL.EN
This confidential document is a property of FALCOM and may not be copied or circulated without previous permission.
Page 144 of 271
