C
ONFIGURATION
C
OMMAND
S
ET
- F
IRMWARE
R
EVISION
2.4.0_
BETA
-
V
ERSION
1.0.0
3.2.23.2 TCP.CLIENT.ALTERNATIVE
Parameter syntax
TCP.CLIENT.ALTERNATIVE=<
This parameter defines an alternative server in case the primary server fails. This
allows to define a fallback server which can be used in case the primary server gets
disconnected/doesn't respond anymore. If both servers aren't available, the device
continues to attempt a connection (alternately to defined "primary" and
"alternative" server). A wait time between 2 connection attempts can be specified
using the setting
TCP.CLIENT.TIMEOUT.
<a_enable>
Enables/disables automatically connection to the remote server. Following
values can be used:
Value
Meaning
0
Disables automatically connection to the alternative
server (
default
).
1
The address of this server will be used for each second
connection attempt.
<a_
ip_address
>
IP address in dotted-four-byte format. It is the IP address to which the MAMBOII
will be registered and send its data. The format of this address is
“xxx.xxx.xxx.xxx”
.
It is also possible to specify a DNS address in the form
(for example
www.falcom.de
) instead of a static IP-address. In such a case it is not required to
set up any DNS provider, it is automatically done.
<a_
port
>
Specifies the port number used for communication between the MAMBOII
device and alternative remote server. See also PORT description.
How the configuration could be set/requested:
Set configuration
$PFAL,Cnf.Set,TCP.CLIENT.ALTERNATIVE=0,217.119.194.35,2222
Get configuration
$PFAL,Cnf.Get,TCP.CLIENT.ALTERNATIVE
Notes
•
All values are separated by commas
“,”
.
•
Contact your network administrator to specify a correct server IP address and
port number.
This confidential document is a property of FALCOM and may not be copied or circulated without previous permission.
Page 192 of 271
