C
ONFIGURATION
C
OMMAND
S
ET
- F
IRMWARE
R
EVISION
2.4.0_
BETA
-
V
ERSION
1.0.0
use them with caution or in combination with just an
event. In the chapter , page
all firmware-supported
States
are
grouped by major category. The
States
are
represented with a
“s“
character directly after the last
dot-delimiter [
.
], for example
Sys.Timer.
s
1=erased
or
IO.Motion.
s
Standing
etc..
If the <
> field includes only
STATES
, the MAMBOII will execute the
specified action repeatedly while the specified
condition remains true. The
combination of states with an event prevents executing of an action
permanently. You use it to specify that an action is to be repeated while some
condition remains true.
Depending on the configuration to be implemented inside the
field, the
events and states, which are available in chapter
page
can be set
.
The following table provides a set of global system events and states grouped by
major category. Some events and states might have special communication
interface requirements and others might have special design considerations. The
links in the table take you to chapter that provides overview description of these
events and states and including specific information for you to consider when
adding these events and states to your application.
Major category
Description
Chapter
Page
System events/states
It provides the event on the serial line and
shows the event signatures.
It provides the events of the device and
shows the event signatures.
It provides the events and states of the
Timer and shows the event and state
signatures.
It provides the states of the Trigger and
shows the state signatures.
It provides the events and states of the
Counter and shows the event and state
signatures.
It provides the states of the Bluetooth and
shows the state signatures.
It provides the events and states of the
Bluetooth audio and shows the state
signatures.
It provides the events and states of the
GPS module and shows the state
signatures.
It provides the events and states of the
GSM module and shows the state
signatures.
It provides the events and states of the
Power and shows the event and state
signatures.
It provides the events and states of the
Battery and shows the event and state
signatures.
It provides the events and states of the
user commands and shows the event and
state signatures.
DISPLAY events/states
Display.dialog
It provides the events and states of the
dialog box and shows the event and state
signatures.
IO events/states
It provides the events and states of the
device motion and shows the event and
This confidential document is a property of FALCOM and may not be copied or circulated without previous permission.
Page 209 of 271
