C
ONFIGURATION
C
OMMAND
S
ET
- F
IRMWARE
R
EVISION
2.4.0_
BETA
-
V
ERSION
1.0.0
PFAL COMMAND SET
MEANING
Chapter
$PFAL,MSG.Version.HardwareRev
Retrieves the hardware revision of the PCB
$PFAL,MSG.Version.Hardware
Retrieves the hardware version of the target device
$PFAL,MSG.Version.Software
Retrieves the software version of the target device
$PFAL,MSG.Version.SoftwareID
Retrieves the software ID
$PFAL,MSG.Info.ServerLogin
Identifies the device to the FALCOM’s Server
$PFAL,MSG.Info.Protocol,<
protocols
>,<”
text
”>
Transmits the selected protocols to the sender
$PFAL,MSG.Info.Time
Retrieves the current system time
$PFAL,MSG.Info.Alarm,<
alarm_index
>
Transmits the selected alarm to the sender
$PFAL,MSG.Channel.SerialGSM
Channels messages from serial port directly to GSM
engine
IEEE commands
$PFAL,IEEE.Keyfob<
kf_div_index
>.LED<
lindex
>=<
config_t
ype
>
Sets and controls LED blinking to a Keyfob
$PFAL,IEEE.Keyfob<
kf_div_index
>.Beep=<
config_type
>
Sets and controls the Beep tones to be generated
on a Keyfob.
$PFAL,IEEE.Keyfob<
kf_div_index
>.Vibration=<
config_type
>
Sets the type of vibration alert on a Keyfob
$PFAL,IEEE.IOBox<
ib_div_index
>.OUT<oindex>=<
config_t
ype
>
Configures the outputs on an I/O-BOX
$PFAL,IEEE.IOBox<
ib_div_index
>.power=<
power_mode
>
Set the operation mode on an I/O-BOX
$PFAL,IEEE.IOBox<
ib_div_index
>.bat.level
Gets battery charge state
Bluetooth-Audio commands
Pairs Bluetooth audio devices
Places both Bluetooth devices in the connection
mod
Closes a currently open audio connection
Table 5:
Complete list of PFAL commands.
This confidential document is a property of FALCOM and may not be copied or circulated without previous permission.
Page 30 of 271