UMN:CLI
User Manual
V5824G
482
11.1.16
Configuring Port/TCONT Threshold
When one GPON port is connected to a lot of ONTs with T-CONTs and GEM ports, you
can specify the maximum numbers (threshold) of T-CONTs and GEM port count. So that
an alarm is generated if a given threshold is exceeded.
To configure the threshold of GEM port count, use the following command.
Command
Mode
Description
olt threshold port
<1-3966>
GPON-OLT
Sets the threshold of GEM port count for ONT.
1-3966 : threshold value
no olt threshold port
Deletes the configured threshold of GEM port.
To configure the threshold of dynamic / fixed T-CONT count for ONT, use the following
command.
Command
Mode
Description
olt threshold tcont dynamic
DYNAMIC_VALUE
[
fixed
FIXED_VALUE
]
GPON-OLT
Sets the threshold of Dynamic/Fixed T-CONT count for
ONT.
DYNAMIC_VALUE: 1 to 384
FIXED_VALUE: 1 to 384
olt
threshold
tcont
fixed
FIXED_VALUE
[
dynamic
DYNAMIC_VALUE
]
no olt threshold tcont
{
dynamic
|
fixed
}
Deletes the configured threshold of T-CONT count.
To display the configuration of GEM-port/ T-CONT threshold, use the following command.
Command
Mode
Description
show olt threshold port
[
OLT-ID
]
GPON
Shows the configured GEM-port/ T-CONT count
threshold of ONTs.
show olt threshold tcont
[
OLT-
ID
]
show olt threshold port
GPON-OLT
show olt threshold tcont
11.1.17
ONU Deactivation Monitoring
ONU deactivation monitoring function generates alarms based on ONU (ONT)
’s
deactivation. The system calculates the current percentage by the number change of
active ONUs every hour. If the number of active ONU is reduced and the current percent
is lower than a given alarm-raise percent, the deactive monitor alarm is on. If the current
percent exceeds the configured alarm-clear percent, the deactive monitor alarm changes
to off. To enable/disable ONU deactivation monitoring, use the following command.
Command
Mode
Description
olt deactive-monitor
{
enable
|
disable
}
GPON-OLT
Enables/disables
ONU
deactivation
monitoring
function.
