UMN:CLI
User Manual
V5824G
56
4.1.6
Auto Log-out
For security reasons of the V5824G, if no command is entered within the configured
inactivity time, the user is automatically logged out of the system. Administrator can
configure the inactivity timer.
To enable auto log-out function, use the following command.
Command
Mode
Description
exec-timeout
<1-35791> [<0-59>]
Global
Enables auto log-out.
1-35791: time unit in minutes (by default 10 minutes)
0-59: time unit in seconds
exec-timeout 0
Disables auto log-out. (unlimited auto-out time)
To display a configuration of auto-logout function, use the following command.
Command
Mode
Description
show exec-timeout
Enable
Global
Bridge
Shows a configuration of auto-logout function.
4.1.7
Telnet Access
To connect to a remote host via telnet, use the following command.
Command
Mode
Description
telnet
DESTINATION
[
TCP-PORT
]
Enable
Connects to a remote host.
DESTINATION: IP address or host name
INTERFACE: interface name
telnet
DESTINATION
interface
INTERFACE
[
TCP-PORT
]
In case of telnet connection, you need to wait for the
[OK]
message, when you save a
system configuration. Otherwise, all changes will be lost when the telnet session is
disconnected.
SWITCH#
write memory
[OK]
SWITCH#
The system administrator can disconnect users connected from remote place. To
disconnect a user connected through telnet, use the following command.
Command
Mode
Description
disconnect
TTY-NUMBER
Enable
Disconnects a user connected through telnet.
!
