User Manual
UMN:CLI
V5824G
521
If you want to set "Bridge", then you should use
omci
.
Otherwise, if you want to set "NAT" or "PPPoE", then you should use
non-omci
.
Basically,
non-omci
configures an interface as "NAT". For the PPPoE, PPPoE
enabling on web interface is required additionally.
Associate the created DBA profiles (
BE
- for Internet & multicast service,
VOIP
- for
VoIP service) to T-CONT.
Associate the created extended VLAN tagging operation profile to each Ethernet
port (
extended-vlan-tagging-operation
V200
- for Internet service (
eth 1
in
this config),
extended-vlan-tagging-operation
V501
- for multicast service
(
eth 2
to
eth 4
in this config)).
Associate the created multicast profile (
V501
) to the Ethernet ports for multicast
service (
eth 2
to
eth 4
in this config).
Configure
ip-host-config 1
.
The
ip-host-config 1
is a host only for VoIP.
- Configure IP address assignment (
static
in this config).
- Associate a VoIP service (
voip-service 1
) to this configuration (
ip-host-
config 1
).
- Associate the created extended VLAN tagging operation profile (
extended-vlan-
tagging-operation
V903
) to this configuration (
ip-host-config 1
).
Configure
ip-host-config 2
.
The
ip-host-config 2
is a host only for
non-omci
-configured interfaces.
- Configure IP address assignment (
static
in this config).
- Associate the created extended VLAN tagging operation profile (
extended-vlan-
tagging-operation
V200
) to this configuration (
ip-host-config
2
).
In case of
ip address
static
, it is required to configure DNS. Otherwise, it is set
to the DASAN-specified value, by default, which may cause to limit any service.
Create a VoIP service (
voip-service 1
) to be associated to IP host
configuration for VoIP (
ip-host-config 1
). And then configure the corresponding
settings. Here, associate the created VoIP profile (
SIP
).
11.2.21.4
ONU Profile & IP Host Configuration (Step3)
The following command lines show a sample config for OLT port corresponding to the
sample scheme above.
OLT(gpon)#
show running-config
...
onu-profile
ONU
create
traffic-profile
TRAFFIC
apply
!
...
OLT(config-gpon-olt[2])#
show running-config gpon-olt
2
gpon-olt 2
olt auto-to-manual enable
olt anti-spoofing enable expire-timeout 60
discover-serial-number start 10
i
