User Manual
UMN:CLI
V5824G
583
To configure a release timer, use the following command.
Command
Mode
Description
release-timer
<0-255>
VoIP-SIP
Configures a release timer. The value 0 specifies that
the ONT is to use its internal default. (unit: second,
default: 10)
To configure a ROH timer, use the following command.
Command
Mode
Description
roh-timer
<0-255>
VoIP-SIP
Defines the time for the receiver off hook condition
before ROH tone is applied. The value 0 disables ROH
timing. (unit: second, default: 15)
11.7.2.6
Network Dial Plan
To configure the critical dial timeout, use the following command.
Command
Mode
Description
dial-plan crit-timeout
TIMEOUT
VoIP-SIP
Defines the critical dial timeout for digit map
processing.
TIMEOUT: critical dial timeout (unit: ms, default: 4000)
To configure the partial dial timeout, use the following command.
Command
Mode
Description
dial-plan part-timeout
TIMEOUT
VoIP-SIP
Defines the partial dial timeout for digit map
processing.
TIMEOUT: partial dial timeout (unit: ms, default: 16000)
To configure the dial plan format, use the following command.
Command
Mode
Description
dial-plan format
{
h248
|
nsc
|
vendor
}
VoIP-SIP
Defines the dial plan format standard that is supported
in the ONT for VoIP.
h248: H.248 format with specific plan (table entries
define the dialling plan)
nsc: NSC format
vendor: vendor-specific format
