UMN:CLI
User Manual
V5824G
548
11.4.5.3
VLAN Tagging Operating
To configure a VLAN tagging operation on the host, use the following command.
Command
Mode
Description
vlan-operation us-oper keep
Traffic-
IP-host
Sets the policy of VLAN tagging for upstream frame.
keep: keeps forwarding the existing tagged/untagged
frame
vlan-operation us-oper
{
add
|
overwrite
}
VLAN
<0-7>
Sets the policy of VLAN tagging for upstream frame.
add: adds a specified VID (double tagging) with tag in
case of tagged frame
overwrite: replaces an existing tagged/untagged frame
to a specified VID with tag.
VLAN: VLAN ID (1-4094)
0-7: CoS value
vlan-operation ds-oper
{
keep
|
remove
}
Sets the policy of VLAN tagging for downstream frame.
keep: keeps forwarding the incoming tagged frame
from OLT to UNI.
remove: removes a tag from the incoming tagged
packet and forwards it to UNI.
no vlan-operation
Deletes the configured policy for VLAN tagging
operation.
11.4.5.4
VLAN Tagging Filtering
If there are more than one mapper connected to VLAN tagging, you need to configure a
VLAN tagging filtering for VLAN ID-based traffic forwarding. To enable/disable VLAN
tagging filtering function on ANI interface, use the following command.
Command
Mode
Description
vlan-filter
[
vid
<1-4094>]
untagged
{
allow
|
discard
}
Traffic-
IP-host
Enables a VLAN tagging filtering function of ANI-side
port.
allow: forwards the untagged frames to the ANI-side
port
discard: blocks the untagged frames to the ANI-side
port
1-4094: VLAN ID(s)
vlan-filter vid
{
add
|
del
}
VID
Adds or deletes the VLAN ID on the VLAN list
configured by
vlan-filter vid
command above.
no vlan-filter
Disables the VLAN tagging filtering function.
