Chapter 8: Using the Command Line Interface
251
If the Restricted Service Agreement feature is enabled, the Restricted
Service Agreement is displayed when any user logs in to the PXE. Do
either of the following, or you cannot successfully log in to the PXE:
In the web interface, select the checkbox labeled "I understand and
accept the Restricted Service Agreement."
Tip: To select the agreement checkbox using the keyboard, press
the Space bar.
In the CLI, type
y
when the confirmation message "I understand and
accept the Restricted Service Agreement" is displayed.
Specifying the Agreement Contents
This command syntax allows you to create or modify contents of the
Restricted Service Agreement.
config:#
security restrictedServiceAgreement bannerContent
After performing the above command, do the following:
1. Type the text comprising up to 10,000 ASCII characters when the
CLI prompts you to enter the content.
2. To end the content:
a. Press
Enter.
b. Type
--END--
to indicate the end of the content.
c. Press Enter again.
If the content is successfully entered, the CLI displays this message
"Successfully entered Restricted Service Agreement" followed by the
total number of entered characters in parentheses.
Note: The new content of Restricted Service Agreement is saved only
after typing the
apply
command. See
Quitting Configuration Mode
(on page 219).
Example
The following example illustrates how to specify the content of the
Restricted Service Agreement.
1. Type the following command and press Enter to start entering the
content.
config:#
security restrictedServiceAgreement bannerContent
2. Type the following content when the CLI prompts you to enter the
content.
Summary of Contents for PXE
Page 16: ......
Page 339: ...Appendix A Specifications 323 RS 485 Pin signal definition al 4 5 6 D bi direction al Data 7 8...
Page 380: ...Index 364 Z Zero U Products 1...
Page 381: ......
