Chapter 8: Using the Command Line Interface
308
Setting the Z Coordinate
This command syntax specifies the Z coordinate of an actuator.
config:#
actuator <n> zlabel "<coordinate>"
Variables:
<n> is the ID number of the actuator that you want to configure. The
ID number is assigned and shown in the PXE web interface. It is an
integer starting at 1.
Depending on the Z coordinate format you set, there are two types of
values for the <coordinate> variable:
Type
Description
Free form
<coordinate> is a string comprising up to 24
ASCII printable characters, and it must be
enclosed in quotes.
Rack units
<coordinate> is an integer number in rack units.
Note: To specify the Z coordinate using the rack units. See
Setting the Z
Coordinate Format for Environmental Sensors
Changing the Actuator Description
This command syntax provides a description for a specific actuator.
config:#
actuator <n> description "<description>"
Variables:
<n> is the ID number of the actuator that you want to configure. The
ID number is assigned and shown in the PXE web interface. It is an
integer starting at 1.
<description> is a string comprising up to 64 ASCII printable
characters, and it must be enclosed in quotes.
Summary of Contents for PXE
Page 16: ......
Page 339: ...Appendix A Specifications 323 RS 485 Pin signal definition al 4 5 6 D bi direction al Data 7 8...
Page 380: ...Index 364 Z Zero U Products 1...
Page 381: ......