Chapter 8: Using the Command Line Interface
224
Enabling IPv4 or IPv6
This command syntax determines which IP protocol is enabled on the
PXE.
config:#
network ip proto <protocol>
Variables:
<protocol> is one of the options:
v4Only
,
v6Only
or
both
.
Mode
Description
v4Only
Enables IPv4 only on all interfaces. This is the
default.
v6Only
Enables IPv6 only on all interfaces.
both
Enables both IPv4 and IPv6 on all interfaces.
Selecting IPv4 or IPv6 Addresses
This command syntax determines which IP address is used when the
DNS server returns both of IPv4 and IPv6 addresses. You need to
configure this setting only after both of IPv4 and IPv6 protocols are
enabled on the PXE.
config:#
network ip dnsResolverPreference <resolver>
Variables:
<resolver> is one of the options:
preferV4
or
preferV6.
Option
Description
preferV4
Use the IPv4 addresses returned by the DNS
server.
preferV6
Use the IPv6 addresses returned by the DNS
server.
Configuring IPv4 Parameters
An IPv4 configuration command begins with
network ipv4
.
Configuration commands are case sensitive so ensure you capitalize
them correctly.
Summary of Contents for PXE
Page 16: ......
Page 339: ...Appendix A Specifications 323 RS 485 Pin signal definition al 4 5 6 D bi direction al Data 7 8...
Page 380: ...Index 364 Z Zero U Products 1...
Page 381: ......