Chapter 8: Using the Command Line Interface
230
Setting the IPv6 Address
After selecting the static IP configuration mode, you can use this
command syntax to assign a permanent IP address to the PXE device.
config:#
network ipv6 ipAddress <ip address>
Variables:
<ip address> is the IP address being assigned to your PXE device.
This value uses the IPv6 address format. Note that you must add
/xx
,
which indicates a prefix length of bits such as /64, to the end of this
IPv6 address.
Setting the IPv6 Gateway
After selecting the static IP configuration mode, you can use this
command syntax to specify the gateway.
config:#
network ipv6 gateway <ip address>
Variables:
<ip address> is the IP address of the gateway. This value uses the
IPv6 address format.
Setting the IPv6 Primary DNS Server
After selecting the static IP configuration mode, use this command
syntax to specify the primary DNS server. If you have selected the
automatic configuration mode, you still can manually specify DNS
servers with this command and then override the DHCP-assigned DNS
servers. See
Overriding the IPv6 DHCP-Assigned DNS Server
(on
config:#
network ipv6 primaryDNSServer <ip address>
Variables:
<ip address> is the IP address of the primary DNS server. This value
uses the IPv6 address format.
Summary of Contents for PXE
Page 16: ......
Page 339: ...Appendix A Specifications 323 RS 485 Pin signal definition al 4 5 6 D bi direction al Data 7 8...
Page 380: ...Index 364 Z Zero U Products 1...
Page 381: ......