Ping Polling Commands
©2008 Allied Telesis Inc. All rights reserved.
Software Version 5.2.1
AlliedWare Plus
TM
Operating System Software Reference C613-50003-00 REV E
63.11
ping-poll
This command enters the ping poll configuration mode. If a ping poll exists with the specified
number, then this command enters its configuration mode. If no ping poll exists with the
specified number, then this command creates a new ping poll with this ID number.
To configure a ping poll, create a ping poll using this command, and use the
ip
command to
specify the device you want the polling instance to poll. It is not necessary to specify any further
commands unless you want to change a command’s default.
The
no
parameter deletes the specified ping poll.
Syntax
ping-poll <1-100>
no ping-poll <1-100>
Mode
Configure mode
Examples
To create ping poll 3 and enter its configuration mode, use the command:
awplus(config)#
ping-poll 3
To delete ping poll 3, use the command:
awplus(config)#
no ping-poll 3
Related Commands
active
clear ping-poll
debug ping-poll
description
ip
length
show ping-poll
source-ip
Parameter
Description
<1-100>
A unique ping poll ID number.