Route Map Commands
©2008 Allied Telesis Inc. All rights reserved.
Software Version 5.2.1
AlliedWare Plus
TM
Operating System Software Reference C613-50003-00 REV E
32.27
set origin
Use this command to add an origin set clause to a route map entry.
When a BGP update message matches the route map entry, the device sets its origin attribute
to the specified value.
Use the
no
parameter to remove the set clause.
Syntax
set origin
{
egp
|
igp
|
incomplete
}
no set origin
Mode
Route-map mode
Usage
This command is valid for BGP update messages only.
Examples
To use entry 3 of the route map called “rmap1” to give matching update messages an origin of
“egp”, use the commands:
awplus(config)#route-map rmap1 permit 3
awplus(config-route-map)#set origin egp
Related Commands
match origin
route-map
show route-map
Parameter
Description
egp
Learned from an exterior gateway protocol
igp
Learned from a local interior gateway protocol
incomplete
Of unknown heritage, for example a static route
