PIM-SM Commands
©2008 Allied Telesis Inc. All rights reserved.
37.8
AlliedWare Plus
TM
Operating System Software Reference C613-50003-00 REV E
Software Version 5.2.1
ip pim crp-cisco-prefix
Use this command to interoperate with Cisco devices that conform to an earlier draft
standard. Some Cisco devices might not accept candidate RPs with a group prefix number of
zero.
Use the
no
parameter with this command to revert to the default settings.
Syntax
ip pim crp-cisco-prefix
no ip pim crp-cisco-prefix
Mode
Configure mode
Example
Related Commands
ip pim rp-candidate
ip pim dr-priority
Use this command to set the designated router priority value.
Use the
no
parameter with this command to disable this function.
Syntax
ip pim dr-priority [<priority>]
no ip pim dr-priority [<priority>]
Mode
Interface mode
Example
Related Commands
ip pim ignore-rp-set-priority
awplus#
configure terminal
awplus(config)#
ip pim crp-cisco-prefix
Parameter
Description
<priority>
<0-4294967294>
The priority value. A higher value has a higher
preference. The default value is 1.
awplus#
configure terminal
awplus(config)#
interface vlan2
awplus(config-if)#
ip pim dr-priority 11234