PIM-SM Commands
©2008 Allied Telesis Inc. All rights reserved.
37.6
AlliedWare Plus
TM
Operating System Software Reference C613-50003-00 REV E
Software Version 5.2.1
ip pim accept-register list
Use this command to configure the ability to filter out multicast sources specified by the given
access-list at the Rendezvous Point (RP), so that the RP will accept/refuse to perform the
register mechanism for the packets sent by the specified sources. By default, the RP accepts
register packets from all multicast sources.
Use the
no
parameter with this command to revert to default.
Syntax
ip pim accept-register list[SIMPLERANGE|EXPRANGE|ACCESSLIST]
no ip pim accept-register list
Mode
Configure mode
Example
ip pim bsr-candidate
Use this command to set this router’s BSR candidate information using the specified IP
interface.
Use the
no
parameter with this command to remove this candidate interface.
Syntax
ip pim bsr-candidate <ifname> [<hash>] [<priority>]
no ip pim bsr-candidate [<ifname>]
Mode
Configure mode
Example
Parameter
Description
SIMPLERANGE
<100-199>
IP extended access-list.
EXPRANGE
<2000-2699>
IP extended access list (expanded range).
ACCESSLIST
IP Named Standard Access list.
awplus#
configure terminal
awplus(config)#
ip pim accept-register list 121
awplus(config)#
access-list 121 ip permit 100.1.1.1 0.0.0.0
Parameter
Description
<ifname>
the name of the interface.
<hash>
<0-32>
configure hash mask length for RP selection.
<priority>
<0-255>
configure priority for a BSR candidate. Note that you must also
specify the HASH (mask length) when specifying the PRIORITY.
awplus#
configure terminal
awplus(config)#
ip pim bsr-candidate vlan2 20 30