Common Multicast Commands
©2008 Allied Telesis Inc. All rights reserved.
35.6
AlliedWare Plus
TM
Operating System Software Reference C613-50003-00 REV E
Software Version 5.2.1
ip multicast-routing
Use this command to turn on/off multicast routing on the router; when turned off the device
does not perform multicast functions. .
Use the
no
parameter with this command to disable multicast routing after enabling it.
Note the default stated below.
Syntax
ip multicast-routing
no ip multicast-routing
Mode
Configure mode
Default
By default, multicast routing is off.
Usage
When the
no
parameter is used with this command, the Multicast Routing Information Base
(MRIB) cleans up Multicast Routing Tables (MRT), stops IGMP operation, and stops relaying
multicast forwarder events to multicast protocols.
When multicast routing is enabled, the MRIB starts processing any MRT addition/deletion
requests, and any multicast forwarding events.
You must enable multicast routing before issuing other multicast commands.
Example
Validation
Commands
show running-config
awplus#
configure terminal
awplus(config)#
ip multicast-routing