Enter 85 End
*/$%ENTR* *ZEND*
Editing General Settings
6
6-2-24.
Set Footer Information
Footer information refers to additional messages which are appended to data output while
the scanned barcodes are sent out in Memory mode. This special parameter allows you to
customize your own custom footer to add clarity of transmitted data.
Procedure
(1)
Scan
Enter
barcode.
(2)
Scan
Footer
barcode to configure the length of the timeout session.
(3)
Please refer to ASCII Code Table and Decimal/Hexadecimal Table in the appendix
to scan hexadecimal value barcodes representing the desired string which has to be
at most 12 characters in length. For instance, to place the employee name "Mark"
in the footer section, scan
4, D, 6, 1, 7, 2, 6
followed by
B
to assign the specified
hexadecimal value “4D61726B”.
(4)
Scan
SET
barcode to complete the variable-binding operation.
(5)
Scan
End
barcode to complete the configuration.
6-3.
Scanner Commands
To perform certain special tasks, you sometimes will use Command Prompt commands to
communicate with the device instead of having your scanner read a sequence of setup
barcodes listed in the manual. In the case like this, you possibly need to rely on escape
characters, no matter predefined or customized, to notify the decoder of the additional
interpretation on the text following prefixed escape characters. The below configurable
parameters allow you to define your own escape characters while you work with a terminal
program to send out command strings to the scanner.
*A70E6*
Footer
A70E6
(Length: 12 digits)
