Enter 160 End
*/$%ENTR* *ZEND*
Setting up your Operation Modes
7
7-4-1-8.
Set Time Delay for a Specified Digit for SPP
This parameter refers to the amount of elapsed time to delay transmitting a specified
character. Please follow the below steps to set time delay for transmitting a specified digit
if the associated operations are performed using RS-232 or USB COM interfaces.
Procedure
(1)
Scan
Enter
barcode.
(2)
Scan
BtSppTxExtTime
barcode to configure delay time for a specified digit for
SPP.
(3)
Please refer to Decimal/Hexadecimal Table in the appendix to scan decimal
value barcodes representing the desired value in the range of 0 to 255. For
instance, to defer transmitting a specified digit for 1 second, scan
1
to assign the
specified decimal value “1”.
(4)
Scan
SET
barcode to complete the variable-binding operation.
(5)
Scan
End
barcode to complete the configuration.
*ACCE0*
BtSppTxExtTime
ACCE0
(Length: 1 digit / Range: 0-255/ Unit: 1000ms)
