Enter 185 End
*/$%ENTR* *ZEND*
Setting up your Operation Modes
7
7-4-2-19.
Set Activation Duration
In general, after Scan button is pressed down, LED light will emit a stream of light for a
scan attempt. This parameter is thus used to specify activation duration which indicates
the amount of time LED light will stays on after Scan button is held.
Procedure
(1) Scan
Enter
barcode.
(2) Scan
BarScanTime
barcode to configure activation duration.
(3) Please refer to Decimal/Hexadecimal Table in the appendix to scan decimal values
barcodes representing the desired value in the range of 0 to 255. For instance, to set
activation duration to be 2 seconds, then scan
2
to assign the specified decimal value
“2”.
(4) Scan
SET
barcode to complete the variable-binding operation.
(5) Scan
End
barcode to complete the configuration.
7-4-2-20.
Set Idle Duration
The device will switch to power-saving mode after remaining idle for a while. This
parameter is thus used to specify the length of time allocated for the scanner to elapse
before power-saving mode is initiated.
Procedure
(1)
Scan
Enter
barcode.
(2)
Scan
BarIdleTime
barcode to configure idle duration.
(3)
Please refer to Decimal/Hexadecimal Table in the appendix to scan decimal value
barcodes representing the desired value in the range of 0 to 255. For instance, to set
idle duration to be 3 seconds, the scan
3
to assign the specified decimal value “3”.
(4)
Scan
SET
barcode to complete the variable-binding operation.
(5)
Scan
End
barcode to complete the configuration.
*BFAE0*
BarScanTime
BFAE0
*BFBE0*
BarIdleTime
BFBE0
(Length: 1 digit / Range: 5-255/ Unit: 1000ms)
(Length: 1 digit / Range: 0-255/ Unit: 1000ms)
