Enter 142 End
*/$%ENTR* *ZEND*
Setting up your Operation Modes
7
7-3-1-22.
Set Activation Duration
In general, after Scan Button is pressed down, LED light will emit a stream of light for a
scan attempt. This parameter is thus used to specify activation duration which indicates
the amount of time LED light will stays on after Scan button is held.
Procedure
(1)
Scan
Enter
barcode.
(2)
Scan
BarScanTime
barcode to configure activation duration.
(3)
Please refer to Decimal/Hexadecimal Table in the appendix to scan decimal
values barcode representing the desired value in the range of 0 to 255. For
instance, to set activation duration to be 2 seconds, then scan
2
to assign the
specified decimal value “2”.
the decimal value “2” by having the barcode scans sequenced as follows:
2
.
(4)
Scan
SET
barcode to complete the variable-binding operation.
(5)
Scan
End
barcode to complete the configuration.
*B9AE0*
BarScanTime
B9AE0
(Length: 1 digit / Range: 5-255/ Unit: 1000ms)
