Enter 90 End
*/$%ENTR* *ZEND*
Editing General Settings
6
6-3-5.
Set <ETX> Escape Character
In general, a valid command string is required to end with a stop delimiter which is appended
to the command code to denote the end of a command string. By associating this
user-defined parameter with the desired control codes, you are able to create your own
custom end digit.
Procedure
(1)
Scan
Enter
barcode.
(2)
Scan
EtxChar
barcode to configure <ETX> escape character.
(3)
Please refer to ASCII Code Table and Decimal/Hexadecimal Table in the appendix
to scan hexadecimal value barcodes representing the desired string which has to be
1 character in length. For instance, to demand a special interpretation for the string
following <ETX> escape character “^”, scan
5
first and then
E
to assign the
specified hexadecimal value “5E”.
(4)
Scan
SET
barcode to complete the variable-binding operation.
(5)
Scan
End
barcode to complete the configuration.
*A54E2*
EtxChar
A54E2
(Length: 1 digit)
