![background image](http://html.mh-extra.com/html/fujitsu/fr60lite/fr60lite_hardware-manual_119677391.webp)
376
CHAPTER 16 DMAC (DMA Controller)
[bit27, bit26] WS (Word Size): Transfer data size selection
Sets the transfer data size for the corresponding channel as follows. DMA performs the specified number of
transfers using the data size specified in this register.
•
Initialized to "00
B
" when resetting.
•
The read / write is possible.
[bit25] SADM (Source-ADdr. count-Mode select) *: Transfer source address count mode
setting
Specifies what to do to the transfer source address for the corresponding channel after each transfer.
Address incrementing and decrementing is performed after each transfer in accordance with the "count size
for the transfer source address" (SASZ). When the transfer completes, the next access address is written to
the corresponding address register (DMASA).
Accordingly, the transfer source address register is not updated until the DMA transfer completes.
To use a fixed address, set this bit to "0" or "1", and set the address count sizes (SASZ and DASZ) to "0".
•
Initialized to "0" when resetting.
•
The read / write is possible.
[bit24] DADM (Destination-ADdr. Count-Mode select) *:
Transfer destination address
count mode setting
Specifies what to do to the transfer destination address for the corresponding channel after each transfer.
Address incrementing and decrementing is performed after each transfer in accordance with the "count size
for the transfer destination address" (DASZ). When the transfer completes, the next access address is
written to the corresponding address register (DMADA).
Accordingly, the transfer destination address register is not updated until the DMA transfer completes.
To use a fixed address, set this bit to "0" or "1", and set the address count sizes (SASZ and DASZ) to "0".
•
Initialized to "0" when resetting.
•
The read / write is possible.
WS
Function
00
B
Transfer by BYTE unit (initial value)
01
B
Transfer by HALF-WORD unit
10
B
Transfer by WORD width unit
11
B
Setting disabled
SADM
Function
0
Transfer source addresses are increased (initial value).
1
Transfer source addresses are decreased.
DADM
Function
0
Transfer destination address is increased (initial value).
1
Transfer destination address is decreased.
Summary of Contents for FR60Lite
