18
B
ASIC
IP C
OMMANDS
The IP interface commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command Parameters
enable ipif
<ipif_name 12 | all>
create ipif
<ipif_name 12>
<network_address>
<vlan_name 32>
{state [enabled|disabled]}
config ipif
<ipif_name 12>
ipaddress <network_address>
vlan <vlan_name 32>
state [enabled|disabled]
bootp
dhcp
show ipif
<ipif_name 12>
delete ipif
<ipif_name 12 | all>
disable ipif
<ipif_name 12 | all>
Each command is listed, in detail, in the following sections.
enable ipif
Purpose
Used to enable an IP interface on the switch.
Syntax
enable ipif {<ipif_name> |all}
Description
This command will enable the IP interface function on the switch.
Parameters
<ipif_name>
−
The name for the IP interface to be created.
all – Entering this parameter will delete all the IP interfaces currently
configured on the switch.
Restrictions none
Example usage:
To enable the ipif function on the switch:
DES-6500:4#enable ipif s2
Command: enable ipif s2
Success.
DES-6500:4#
create ipif
Purpose
Used to create an IP interface on the switch.
Summary of Contents for TM DES-6500
